Based on what you have said, it's most likely the Forward switch or a bad connection to it.
Type: Posts; User: DickB
Based on what you have said, it's most likely the Forward switch or a bad connection to it.
When you say it won't move when displaying the dash, does the engine rev slightly then back down (like when you twist the throttle with the parking brake on)?
If it were the gearbox, I doubt this...
Consider adding auxiliary lights such as Denali.
I doubt it is going into "neutral" but you likely have a bad Forward or Reverse switch on the gearbox or a poor connection. There are switches for Forward, Reverse, and Park brake - if none are...
There is a fix for a stuck float.
The tank is unique to Rykers. It is an odd shape and due to the location of the float it has huge dead spots at the top and bottom of the tank, but does read...
From the Service Manual.
There is a float that is a part of the fuel pump assembly. The pump has to be aligned precisely to prevent the float from sticking. Try rotating it slightly to see if it frees up.
Yes. Google maps is your friend.
Service manuals for Spyders are relatively inexpensive, and well worth the cost if making your own repairs.
https://canammanuals.com/product-category/rykers-spyders/
Parts for a 2014 are...
What he said. Mount them low and run them in the daytime also: https://www.nhtsa.gov/document/motorcycle-conspicuity-and-effect-auxiliary-forward-lighting
Sorry - my mistake.
I show the part number as 420256454 and available from several sellers on eBay and Amazon.
You can do exactly that with BUDS.
It simplifies wiring. Look at the number of buttons/switches on the left handlebar. I have two paddle switches, Reverse switch, 6 display switches, and turn signals. All those plus a ground, that's...
There is a heat shield on the exhaust manifold left side.
It sounds like you found the cause of a problem that you introduced. Have you found the cause of the problem that you had in the first place?
My post only applies to a very specific case, not shifting in general. By holding the paddle a bit longer when attempting to shift from 1st to N, I was unintentionally invoking a double shift. But,...
The intake plastics are notorious for making a rattle or buzz. Many have added weatherstrip to quiet them. Do a search.
Try searching "2011 Spyder RS" on eBay. If you find a seller for any part, try contacting them to see if they have a cluster. Salvage operators may not post all the parts that they may have available.
I expected to find it under "Body" but did not. I did a search on "position light" to find it.
Service manuals are acessible at powersports-diag.com if you have a login.
Service manuals are also pretty reasonably priced here:
https://brpmanuals.com/product-category/rykers-spyders/
I have a 2014 RSS that I recently bought used. It has standard turn signal bulbs, but the previous owner had installed amber and red LEDs in place of the reflectors on the fenders. Don't know if that...
I changed color on one of my helmets with a rattle can.
I've been riding my 2014 RSS for about a month. When I tried to shift from 1st to Neutral, sometimes nothing would happen. I would have to do it 2 or 3 times to get it to work. I recently came across...
Religiously.
Yes, I screwed up when I said "TCM connector". When you disconnect the solenoid connector, you make the resistance test using the connector end that runs to the solenoids. When you make the test...
I'm a bit confused by this, as the test light is not used for the resistance test. Disconnect the solenoids connector, run the engine, put your test light on pins 8 and 1 at the solenoid connector...
I took my rear wheel to the local tire shop. They said they could mount the tire but not balance because the hole was too small. I got it done at a Can Am dealer, they wanted the brake rotor on to...
I picked up a used Ryker SAS for $70 and a used Spyder yaw rate sensor for $30 on eBay. Both worked fine. I do have BUDS to calibrate them.
Service manuals are cheap and well worth the cost:
https://www.flipbookpublishing.shop/#/