Search:

I edited with an update. :)

I wound up taking it to a stealership. It was the only way to clear the codes. 2 hours and $333 later, it's doing ok. I still have to address the low rpm 1st gear...

Message sent. :-) Thanks!

Thank y'all!

The battery has been replaced. I took it for a ride. It won't come out of limp mode. P.a.r.t.y. My 2008 with 32k runs perfect. This 2010 RSS is troublesome at 12k.

Is there a shop that anyone knows of in NE Ga with buds that's not a stealership? I need to get some codes cleared and brakes bled.

New battery. Went for a test ride. Got a new code. Yay me. Now we have 4.
OC1282 (brake pressure)
C0051 (steering angle)
P2545 (speed sensor)
U0122 (communication loss).
We'll have to...

Did you resolve this? I got both these codes and found my battery terminals loose. The battery was also bad. I have replaced it but have not take it for a drive yet.

2010 Spyder RSS multiple codes arrrggg!! Me again!!

Sooo... I only had code OC1282 (Brake pressure). I took it for a short ride and got limp mode "V55 check DPS. I pulled the codes and now I have...

Thank you!!!!!

So the pulley was shot. I ordered by part number and apparently got an upgraded pulley. It has flanges on both sides. It also came with a spacer. Does the spacer go inside the pulley between it and...

Thank you! I got a OC 1282 (Low pressure). It won't reset (new brakes, bled the lines and the antolock unit). Next step is testing the fluid. It won't reset. This spyder had this issue when I picked...

I know I've asked quite a few questions, but can you pull codes on a 2010 RSS by pressing the mode/start/blinker cancel buttons? When mine are pressed, I just get the options to change to kilometers...

That's odd. My other spyder came with the pulley on it the same way as well. Very possible though.

It was ridden about 100 yards forward. That's it.

I just picked up a 2010 spyder RSS. I noticed a belt noise. When I looked I saw this (see pics). My question is, will adjusting the belt in the back move the belt on the front pulley back in place as...

What worked for you??

Thanks for the replies! She lives and rides great!

EDIT: I figured it out. The parking brake arm had to come off. :-)

I'm doing the brakes and noticed my caliper will not retract. I've read two different procedures on how to make it retract. Does...

I just picked up my 1st spider! The belt was off. I found the pulley bolt to be out and the pulley to be unusable. I ordered a new pulley. I have 2 questions.
1. Bolt torque spec for the pulley. ...