Jiffy, that is a great post. I have the brp shad saddlebags and they stick out awlful! Wish to tuck them in somehow, or get the new ones. Really would like a top box back there. Thank you so much for...
Type: Posts; User: tim1
Jiffy, that is a great post. I have the brp shad saddlebags and they stick out awlful! Wish to tuck them in somehow, or get the new ones. Really would like a top box back there. Thank you so much for...
his post is mike p if I can bring them up.
Darn it, where did I see the post on the givi rear trunk on a f3s, had side bags too kinda square? Thanks Fellas Tim
Thanks fellas, with the small amount of riding I do anymore, I will go by the dealer and get the kit. Very good info here! Tim
I did not know you could get a kit from brp that was full synthetic, thanks.
Thanks fellas, i was concerned 9k miles on any oil was too much, never used synthetic oil though, but I am old school with 3k oil changes. Good point on the filter change each time. Tim
Fellas i have a 2015 f3s with 13k miles. My (new to me) first oil change, will use oem oil filter, but the oil viscousities are all over the place, 5-40, 10-40,20-50, etc. I like the castrol 4t bike...
Wow, you must of got a good sprocket, amazing, so there is hope! Tim
I hope you used a new bolt, one time use.
done this job at 12 k and surprised yours lasted 34k. My sprocket slid on easily all the way to the collar with no pounding. Did you use a new sprocket....
My doctor asked me if I wanted to be put out for the colonostopy, and I had to say "who are you?", of course I do.
I drilled the factory #4 position rod and it put the pedal at just the right height, just slide over and apply the brake. The more i thought about the extra hole in there, I ordered Lamonster brake...
Update; Took a 200 mile trip today with the windshield 25inch and it it a bit short. I will have to live with it as they say at 7jurock, you mount it, you own it. Fair enough. tim
Hey megarner, centered is the alignment, the cricket will tell you the tension. Not critizing, just clarifing. Tim
I just installed the 25 inch 7jurock shield. Could of used another set of hands to install. At 5' 9 I thought about the 27, but was not going to cut down if I had to look thru it. The 25 is about 3...
yokohama s drive 95.00 free shipping 8.00 to mount + Lamonster wheel balancer , but free is free!!!!
if there is a next time, may be 660. we will see in 12k miles.
ordered the 2 up shock off brp wed site, cost 150.00 free shipping. Took 15 min to install. Here is how; Remove 2 nuts from shock bolts 15mm and socket is on a wobbly,not a universal swivel. 3/8...
Thanks fellas for the replies. Tim
Hoping for a full recovery, she is truely blessed. Thanks for the update. doc. Tim
The yellow locktite they use is reusable and you can check your torque to 95 lbs.Mine was tite and inside pulley toast. If you remove the bolt, clean it with acetone and use blue locktite and...
If you see red dust, wear is happening in the sprocket splines, not the gearbox shaft. Dealer may or may not do anything. Do not remove bolt unless you have a new one, one time use. When I removed...
I installed the yokohama tire at discount tire for 8.00 and removed 12 of those sticky weights of of the rim. I put the centramatic on and it is smooth as I can tell at 24psi. Was I supposed to...
I also see my belt move a little so I run mine dead center on the sprocket to maybe a little towards the flange, but no way tight on the flange. Do not know where it is on the motor sprocket as have...
ditto on lamonster, very good product! tim
Installed backrest and belt tensioner and they work great, also new yoko back tire, with lamonts wheel balancer, front sprocket, and # 4 position linkage. What a differance. Cricket set at...
For, I cannot see 5 mm, but I can see if it is centered on the pulley, works for me, if slightly towards the flange, even better, but never up against the flange. Tim
Any of you folks that have this sport fender, does it rooster tail the water onto your back? Hopefully it will stop some. I like the setup and we get rain in Oregon. Thanks Tim
You really need to look at the video of doc humphreys pulley before you buy one, world of differance. Tim
Hey buddy, for what it is worth, there is a sidecar guru in Washinton Named Jay at Dauntless Sidecars and he truly is amazing. It would not hurt to pick his brain a bit, he is old like us and has...
Had to delete my other post, got flamed real bad by some, not all. Taking to dealer next week to check alignment and gonna ride a f3 to compare, not done yet. Tim