Search:

Type: Posts; User: JohnMc

Page 1 of 2 1 2

Search: Search took 0.01 seconds.

  1. It should go back to normal. No different than...

    It should go back to normal. No different than replacing battery.
  2. Replies
    3
    Views
    595

    You will have to replace the entire switch. I...

    You will have to replace the entire switch. I tried taking one apart to just get the button and stuff. There does not appear to be a way without ruining the thing. You will have to take right side...
  3. Replies
    17
    Views
    3,709

    I should have said to back it onto the ramps. ...

    I should have said to back it onto the ramps. That keeps them out of your way.
  4. Replies
    17
    Views
    3,709

    Drive it up on two car ramps and jack up the rear...

    Drive it up on two car ramps and jack up the rear at the shock.
  5. Replies
    3
    Views
    1,117

    I have had the BRP arm with the Lamonster roller...

    I have had the BRP arm with the Lamonster roller for a few months. No problems so far.
  6. Thread: Help!!

    by JohnMc
    Replies
    7
    Views
    1,431

    Do not delete cat if you want to keep low end...

    Do not delete cat if you want to keep low end torque.
  7. Replies
    31
    Views
    3,811

    I am not sure where I read it, but the ignition...

    I am not sure where I read it, but the ignition will not fire with the throttle at wide open. I verified this and have been using the technique in conjunction with oil changes. I do this because...
  8. I like the Kaos version because the exhaust is...

    I like the Kaos version because the exhaust is further back and will reduce the sound for the rider and passenger.
  9. Thread: Slingmods

    by JohnMc
    Replies
    26
    Views
    8,150

    Great customer service and quality products.

    Great customer service and quality products.
  10. Replies
    19
    Views
    7,496

    I would not use an auto car wash spray on any...

    I would not use an auto car wash spray on any areas under the plastic. It is not very hard to remove the plastic from that side to allow you to get in with rags and low pressure cleaner from a spray...
  11. Replies
    26
    Views
    8,280

    Great job!

    Great job!
  12. Replies
    14
    Views
    4,602

    I would think you need to take the belt off the...

    I would think you need to take the belt off the front pulley to give you slack.
  13. Replies
    11
    Views
    1,876

    I upgraded and F3 to the 2 up shock. There is...

    I upgraded and F3 to the 2 up shock. There is quite a difference in that shock versus the original. The 2 up is much more hardy. I am pleased with the result. I installed it myself and were it...
  14. Replies
    43
    Views
    8,250

    I was in the same boat. I battled with that damn...

    I was in the same boat. I battled with that damn screw for several hours before giving up and strapping things in.
  15. Replies
    24
    Views
    6,916

    I am going to add cc to my base model. I...

    I am going to add cc to my base model. I purchased a used control off ebay for a really good price. Now, I am wondering if I can just replace the dummy button from my current control with the...
  16. Replies
    20
    Views
    3,167

    I live in New Orleans and have ridden to northern...

    I live in New Orleans and have ridden to northern Arkansas and enjoyed riding in the mountains. The total trip was a little shy of 2000 miles and my basic F3 SM6 did just fine. At the time I did...
  17. Thread: Wire in power

    by JohnMc
    Replies
    8
    Views
    1,946

    HowTo: I have a basic F3 sm6 and it has the accessory...

    I have a basic F3 sm6 and it has the accessory circuit under the seat. I am guessing they all have them.
  18. Replies
    10
    Views
    1,813

    No good can come of putting something in your...

    No good can come of putting something in your tires, other than air or nitrogen and nitrogen is a waste of money.
  19. Replies
    43
    Views
    11,288

    IRA non-penalty withdrawals can begin at 59 and...

    IRA non-penalty withdrawals can begin at 59 and one-half
    If you wait on SS until your full benefit age, there is no penalty for other income.
    You do pay Federal income tax on SS if your total...
  20. Thread: Spyder F3 Parts

    by JohnMc
    Replies
    16
    Views
    2,915

    The two up shock still there, if so, I would like...

    The two up shock still there, if so, I would like to purchase. Let me know shipping to 70123.
    Thanks,
    John Mc
  21. Replies
    11
    Views
    3,416

    I am not sure the non-mandrel pipe would be all...

    I am not sure the non-mandrel pipe would be all that bad. The wrinkles may just add to the necessary back pressure for the low end. Wish some one would try one with a less aggressive baffle (such...
  22. Replies
    6
    Views
    2,410

    See if these help you make up your mind. ...

    See if these help you make up your mind.

    http://www.spyderlovers.com/forums/showthread.php?102206-F3-Clutch-updated-to-vacuum-assist&highlight=vacuum+assist
    ...
  23. Replies
    11
    Views
    1,498

    More moving parts.

    More moving parts.
  24. Replies
    3
    Views
    1,307

    Floor Boards

    Mark,
    I guess I finally figured it out. You should have payment.
    John McDaniel
    132 Arnold Ave.
    River Ridge, LA 70123

    Thank you
  25. Replies
    3
    Views
    1,307

    Floor Boards

    Hi Mark,
    I called you number and got no answer. If you still have and give me total, including shipping to zip 70123, and how to pay, we will be in business. Thanks, John Mc cell 504-858-2190
  26. Replies
    7
    Views
    5,442

    2015 F3 Clutch Assist

    OK all. I did it. Some free advice and worth every penny. Buy just the solenoid and check valve from a can am dealer. Buy two packages of 10 of the 3/8 inch spring clamps for fuel and vacuum...
  27. Replies
    7
    Views
    5,442

    Thanks to all for the replies. I believe the kit...

    Thanks to all for the replies. I believe the kit is for installing RT components onto an F3. That would be why some dealers are saying replace with RT clutch. The going price for labor is about...
  28. Replies
    7
    Views
    5,442

    Wow, The RT clutch option is very interesting. ...

    Wow,
    The RT clutch option is very interesting. I had never hear of that. As to the parts listing for the vacuum assist, I had that. I am looking for installation instructions. Anyone have more...
  29. Replies
    7
    Views
    5,442

    2015 F3 clutch vacuum assist

    Hi all,
    Does anyone have a copy of the Can Am memo that has instructions for installing a vacuum assist on the F3? If I could get a copy, I would really appreciate it. Thanks in advance.
    John Mc...
  30. Thread: F3 shift pedal

    by JohnMc
    Replies
    6
    Views
    1,859

    Shift Pedal

    Got it! Thank you.
Results 1 to 30 of 34
Page 1 of 2 1 2