Search:

Type: Posts; User: zbunker

Page 1 of 5 1 2 3 4

Search: Search took 0.02 seconds.

  1. Replies
    3
    Views
    743

    I feel your pain while riding I started getting a...

    I feel your pain while riding I started getting a C0040 and a C006C error code then P05040 and P061E.
    (Referred to brake lights. -Ain't got them- possible fuse)
    Of course check engine flashing all...
  2. Replies
    78
    Views
    13,203

    road crown drift

    Hi
    Here's my story. I had a new 2013 RT. Right outta the box, I had steering issues. Toe out was real bad. I was all over the road. A laser alignment cured it. Upgraded to a 2014 RT and found a...
  3. Thread: A*s Wipe

    by zbunker
    Replies
    102
    Views
    21,384

    Alaska vs Chicago

    Things are worse in Chicago because of their stricter gun laws :D
  4. Replies
    1
    Views
    958

    switches

    Hi, from left to right the switches should be:
    Brake, Grip heater, Rear shock adjust, Fog light.
    Ron
  5. Replies
    7
    Views
    2,050

    Stuck Brake

    Yeah, tried all sorts of combinations, NG
    I'm kinda thinking along the lines of a lousy switch contact.
  6. Replies
    26
    Views
    7,282

    Belt Vibes

    Hi, I have the aftermarket tenisoner and it works okay. This is the first time I have heard of the BRP model. But as reducing the vibration on deceleration, it is the top of the belt that tends to...
  7. Replies
    7
    Views
    2,050

    F-3 Parking Brake does not realease

    Hi all,
    Hows bout this for a "Good One."
    2016 F-3; Start it up, Shift to first, Push the switch to release the parking brake,
    and the brake does NOT release.:banghead:
    Tried backing up, going...
  8. Replies
    40
    Views
    10,465

    Gas milage

    Riding under 4K RPM helps.
  9. Replies
    29
    Views
    9,760

    Overfill

    I drove a lot of Fords too. Sometimes you had to add before you arrived:roflblack:
    But seriously, I check before I leave also. I can't get the concept of firing up an engine and running it until...
  10. Replies
    25
    Views
    6,855

    Pulling

    I'm in the same boat. Everything is like it's supposed to, (including reset sensors) yet I still drift to the right.:banghead:v
  11. Replies
    82
    Views
    39,163

    Vibration between 70 and 80 MPH

    Hi,
    sounds like you changed the wave length of the belt. And in doing so might have canceled out the initial vibration. Like you added an extra wave. Something like the DOLBY noise canceling...
  12. Replies
    46
    Views
    25,729

    BREAKFAST MEET & GREET DURING BIKEWEEK??

    Hi Chris,
    Sylvia and I are "sounding off" in the positive. Throw out some dates.
    Ron
  13. Replies
    82
    Views
    39,163

    vibrations at high speeds

    Hi I have had 3 RTs. 12 13 14. They all had vibrations starting around 74 mph. I have a belt tensioner on the 14. It helps but don't cure. I still get the vibs in the 80s. I think there are two...
  14. Replies
    10
    Views
    3,949

    rotational brake squeak

    Hi, I too had that squeak in the rear brake pad after the rear wheel was removed to repair a flat. And yes, the problem was a missing spacer.
    Sounds like the classic "parts left over syndrome":joke:
  15. Thread: Paint Touchup

    by zbunker
    Replies
    10
    Views
    3,801

    Paint Touch up

    Hi
    Bummer :cus:
    For touch up paint, I would suggest www.TouchUpDirect.com
    They carry paints for Can Am machines. Use discount code 'touchupall10'
    Good luck
    Ron
  16. What is a Spyder. Bike or Motorcycle?

    Hi
    Whatever you call it, by virtue of the word 'BI' ke, it certainly can't (although often is referred to as) a bike.
    You could say my machine.
    I guess it's a UFO.......U FIGURE IT OUT...
  17. Sticky: Special Tools

    My special tools consist of a pair vise grips and a hammer...........
    And can't forget the duct tape and zip ties :joke:
  18. Sticky: Proper Oil Level Verification Procedure on 1330-engined Spyders

    Hi,
    One would think there would be a better way to check the oil level. Just imagine you come home from an all day into the late evening ride. The next day, you see a puddle of oil under the...
  19. Replies
    15
    Views
    6,091

    Found another place for pure gas

    Hi,
    I noticed that some, not all, WAWA gas stations have ethanol free 89. The stuff is a bit more expensive than Hi Test. I have been using it when I can and my '14 RTL likes it. Mileage-wise it's...
  20. Part # for a shop manual needed. I already searched

    Hi,
    If this helps at all. I have a 2013 Roadster shop manual for Spyder series. Covers the RS, ST, and RT
    part # 219 100 736
    It looks like you might be looking for 219 100 636
    There is a...
  21. Replies
    106
    Views
    37,408

    Inspection Sticker not staying attached

    When all else fails you can always try thumb tacks or staples.:joke:
    Ron
  22. Replies
    49
    Views
    16,938

    Does Noisy Fuel Pump = Break Down??

    Hi,
    Yep, that is the noise I was referring to. NICE JOB:thumbup:
    Now to me, it seems like there can be two troubles. One being the noise of the pump when running, and the second when the pump...
  23. Replies
    12
    Views
    4,017

    USE A JACK LIKE THIS

    Hi,
    It looks like you have an ST up in the air. I have an RT with a Bump Skid. I don't think I could do that. I would have thought placing the jack where you have it would be lifting from the...
  24. Sticky: Proper Oil Level Verification Procedure on 1330-engined Spyders

    It's easy to comprehend. The BRP design engineers get paid by the hour.

    It's like FORD products. You need a box full of "special tools" to work on their cars. Those design engineers go out and...
  25. Replies
    16
    Views
    4,178

    A fuel Question

    Hello all,
    I found a place that sells ethanol free fuel. I always run Hi-Test (91) on my '14 RT and get mileage in the 30's depending on the type of riding. The ethanol free fuel is 87 octane...
  26. Replies
    49
    Views
    16,938

    Does Noisy Fuel Pump = Break Down??

    Hi All,
    There seems to be a lot of folks starting to report fuel pump noises. (Me Too) My question is: Has anyone had a breakdown as a result of a "bum" fuel pump?
    Ron
  27. Replies
    88
    Views
    39,947

    Very noisy fuel pump

    Me too. My machine has been idle for about a month. When I started it up to move it out of the garage, I heard a strange noise coming from under the Tupperware. I determined it was the fuel pump by...
  28. Replies
    27
    Views
    8,140

    Shifting in the 2014

    I see that some are questioning what type of machine you have. From your Avatar, it looks like an RT. Now, I guess the real question is the type of transmission you have. I also have a '14 ES-6. I...
  29. Replies
    31
    Views
    5,455

    Connection problems

    Yeah Bob me too. I would have told you sooner, but I couldn't log on:roflblack::roflblack::roflblack:
    Had trouble for 2 days.
  30. Replies
    10
    Views
    4,408

    Center Console Switch

    Thanks, As far as the switch type, what I had in mind was to order a switch from the dealer that is identical to the fog light switch. It would show a light symbol, and if everything goes like...
Results 1 to 30 of 150
Page 1 of 5 1 2 3 4