Finished it, and really enjoyed it! Looking forward to the next one!
John
Type: Posts; User: jpcoder
Finished it, and really enjoyed it! Looking forward to the next one!
John
Thanks for the info! Updating maps and a new voice (Samantha) now.
I disconnected cable because of the commercials. Now its Netfilx and Amazon prime.
Went to SpyderComfort in Landrum SC on Saturday and got a laser alignment for my 2015 RT LTD. Mike did a great job in about an hour. I could feel the difference in how the spyder handled immediately....
GOOACC Nylon Bumper Fastener Rivet Clips Automotive Furniture Assembly Expansion Screws Kit Auto Body Clips 8mm - 40PCS
Free shipping with amazon prime.
I was missing one, so got these and...
Just received a blank ignition key I ordered for my 2015 RT Ltd. Part # 710004408. Got it from Florida Central Powersports thru Amazon. No shipping, no tax. best deal I found. Finding a place to get...
It took about 2 hours to do the install. I have a motorcycle lift from Harbor tools and it will go high enough to remove/install the sway bar. Be careful at that height, I almost knocked it off the...
I installed Baja Ron's sway bar on my 2015 RT Ltd yesterday and was surprised by how easy it was to do. Was only able to take a short ride around the neighbor hood, but the improved handling was...
Great answers!! Thanks!
I bought the bike used, but don't think it had a CB on it.
I've checked the service manual and can't find the purpose for the audio looking connector near what appears to be 2 sensors on the right side of the fuel tank on a 2015 RT. Anyone know what this...
ID of a 6205 is 1 inch.
Thanks for the info on the service manual! The circlip is part of the sprocket and not part of the wheel. For the wheel, its bearing, inner tube, bearing. The issue is not being able to get any...
Tried it, no way to get between the bearing and the inner tube. Inner diameter of the tube same as bearing.
Here is a picture of the wheel.155168
Has anyone had to change the bearings on a 1 piece rear wheel with the tube between the 2 bearings tight up against the bearings on both sides? If so, how did you do it?
So, I replaced all 3 tires with car tires, cleaned the brakes and rebuilt the rear hub. It rydes and handles much better than it did.
Damper blocks appear to be OK, but I am replacing them anyway. The O ring was damaged, and I am replacing it as well. I should have the parts by end of the week and will try it again. While its all...
I put a General Altimax RT43 215/60r15 on the rear and Federal Evos on the front. Both selections made after research on this site.
Yes, that spacer is oriented correctly.
Hi,
I changed my OEM tire to the General Altimax, and when I reassembled, it seems that the sprocket no longer sits tightly against the wheel. When I got the belt aligned, it is very close to up...
Hello, I have a new to me 2015 RT Limited with about 7900 miles on it, about 500 are mine. No problems with the brakes until yesterday when we took a ride the Blue Ridge mountains doing some...